The normal use steps of Cabinet Style PSA Nitrogen Generator For 3D Printer equipment
Cabinet Style PSA Nitrogen Generator For 3D Printer is based on the principle of pressure swing adsorption, using high-quality carbon molecular sieve as the adsorbent, and producing nitrogen from the air under a certain pressure. Let's understand the normal use steps of Cabinet Style PSA Nitrogen Generator For 3D Printer equipment:
1. Turn on the power supply of the cold dryer, and transfer the empty car for 3-5 minutes;
2. When the air compressor is turned on, the compressed air enters the air buffer tank of the nitrogen generator after being processed by the refrigerating machine and the filter, and the indication of each pressure gauge gradually rises;
3. When the pressure of the air buffer tank reaches the high pressure set by the air compressor, turn on the power switch on the electric control cabinet to enter the normal working state;
4. When the pressure of the nitrogen storage tank reaches 0.6Mpa, slowly open the vent valve. At this time, the float of the flow meter can be observed to rise.
I hope the above mentioned about Cabinet Style PSA Nitrogen Generator For 3D Printer equipment content will be helpful to everyone's work.